Forscan for 2022

Damn ok. I’m trying to figure out how to see the tail gate camera and 3rd brake light camera at speed and saw that. I wasn’t sure what it did.
My truck had both of these views enabled at speed from the factory.
 
I was reading through some of the "what have you done to your tremor today" forums and i came across someone who activated the runnings lights with their DRLs. Is this still something we can do with the 2022s? Would it be in the plain english section? Looking to have the mirrors and taillights on during the day (my f150 did this and it also keeps my trailers running lights on during the day as well).

Thanks!
 
I was reading through some of the "what have you done to your tremor today" forums and i came across someone who activated the runnings lights with their DRLs. Is this still something we can do with the 2022s? Would it be in the plain english section? Looking to have the mirrors and taillights on during the day (my f150 did this and it also keeps my trailers running lights on during the day as well).

Thanks!
From another thread, courtesy of @Modman I believe this will work for you:

This worked a treat! Name of the plain English setting is slightly different, though. Here's the specifics:

Module: BCM
Setting name: DRL include park lamps
Original value: Disabled
New value: Enabled

Validated it worked by doing the following before and after making the change:
  • Key on, engine off
  • Lights in "Auto" in bright enough light to not need headlights
  • Put truck into neutral (parking brake on)
  • Got out of truck and checked both front and rear lights
Before the change the last step revealed just the C-clamps up front being on. After the change revealed the same, as well as the tail lights being on.

Going to run with this for now and see if I get any complaints about not having my headlights on. If not, I'm set! If so, I'll explore some of the other options.

Thanks so much everyone!
 
Does anyone know the value change to flatten the EQ on the B&O setup on my 2022 F250? I tried the F150 one and crazy things happened with my radio being stuck on AM. Clearly, it wasn't the right coding for this 2022 F250's.
 
I added DPF% and the auto regen checkbox using forscan (both done in as-built), in doing so I lost the DEF% guage in the maintenence monitor section and in the gauge selection in truck settings. Has anyone else had this issue? I have no way of seeing my DEF% now.

UPDATE:
Thanks to post #890 in this thread by @HeavyAssault I was able to figure it out. Now I have DPF%, Auto Regen check box, and DEF%. It all has to be done in plain english. I don't know how I missed that post. Thanks @HeavyAssault!
 
Last edited:
Boot animation where in forscan do I go to change it on my22, is the 75th anniversary boot display available?
 
Friendly bump. Just in case here have been any new discoveries!
 
Just finally got to forscan updates, having issues with silent mode. I'm able to activate it and it works, but not get a display toggle on my vehicle display screen. I've been using plain English under the APIM but its not accepting. Anyone know how to go about having an easy way to turn off and on this option? Appreciate the help.
 
What I'm most curious about is the factory eq rolloff. Would it be similar to the new f-150's since I have a 22'
 

Attachments

  • 20230629_204641.webp
    20230629_204641.webp
    136.3 KB · Views: 58
@ffsmith20 give this a try
APIM AsBuilt 7D0-03-01 xxxx 24xx xx--
Soft Reset the APIM after write and key cycle (Pwr+FF)

ZooDad
 
Back
Top Bottom