Upfitter Switches, What are you using them for?

[torino420]

1 - (SEIC) High Idle
2 - Horn Switch ( between regular and train horn)
3 - Z-Flash from Ultra Bright
4 - BD Rear Lights
5 - Front Light Bar
6 - Ejector Seat

What are you guys using for the Winch Power disconnect via upfitter?

If you don't mind, how do you have #2 wired to swtich between horns? I'm wanting to do the same.

 

[BroncOh]

1 - (SEIC) High Idle
2 - Horn Switch ( between regular and train horn)
3 - Z-Flash from Ultra Bright
4 - BD Rear Lights
5 - Front Light Bar
6 - Ejector Seat

What are you guys using for the Winch Power disconnect via upfitter?

When I do my factory winch install, I'm going to open the Warn control box and run the solenoid +12V wire that's already in there to an upfitter switch. No point in adding another solenoid when one exists.

 

[Bitsniffer]

If you don't mind, how do you have #2 wired to swtich between horns? I'm wanting to do the same.

2008-2022 Ford Super Duty Train Horn Integration Harness

This PLUG and PLAY harness allows you to integrate an aftermarket train horn to work with your original horn button in the steering wheel when the upfitter or customer supplied switch is activated. FITS 2008 - 2022 FORD SUPER DUTY / Alumiduty trucks.

limitlessautoworksllc.com

 

[Gus]

Need to figure out what to hook to the upfitter switches as iv bypassed them

 

[Tominator]

I am close to ordering a new truck. I am curious what most people are using the upfitter switches for. I am trying to decide if is worth adding to the new truck.

So far, Air Compressor

 

[t0lbert]

what high idle kit are you all using?

 

[Bitsniffer]

No kit. Just adding a resistor to your choice of upfitter switches. Here is the Powerstroke TechTalk from A-rod -

 

[MrFancypants]

1 - 2LO (replaced/repinned with NC relay)
2 - Open
3 - SEIC @ 1500 rpm
4 - BCP
5 - Open
6 - Rear hitch lights

 

[t0lbert]

No kit. Just adding a resistor to your choice of upfitter switches. Here is the Powerstroke TechTalk from A-rod -

right on. so if want 1250rpm, i gotta find a 19k resistor?

 

[t0lbert]

can anyone help me where the 'pass thru' 4 wires on around the pass kick panel on a 21 tremor?

 

[Vecman]

1 - pocket lights (SAE & Squadron Pro combo)
2 - Front light bar Onyx6
3 - empty
4 - reverse lights
5 - empty
6 - air compressor/air bag system

I have two other switches installed on the driver side dash, for rock lights and cargo lights on my third brake light antenna mount, and then a dial below for STOF tuning choices. There will be an additional switch next to the pedal positioning switch for the front e-locker

 

[MTUcrash]

1-auxiliary reverse lights
2-rear locker alternative lock
3-front fog light bar
4-front cornering off-road lights
5-front center off-road lights
6-ham radios
Also dial on dash for high idle

 

[Rodd187]

can anyone help me where the 'pass thru' 4 wires on around the pass kick panel on a 21 tremor?

Here is a video that might help. I did not have to remove the battery box for my 2022 but you may for the 2021. Sorry the video wont let me share it, search "2021 Super duty upfitter switch and path through wiring" on YouTube


Here is a also a thread with other pics. Hope it helps buddy!

Firewall pass through wires locations

I am trying to locate the pass through wires on the 2020 model under the hood and in the cab, and googling only shows me 2019 and earlier. It doesn't appear to be the same layout as far as I can tell. Does anyone know where the 4 pass through wires are on the 2020's (and if they even exist as...

www.fordtremor.com

 

[soulezoo]

can anyone help me where the 'pass thru' 4 wires on around the pass kick panel on a 21 tremor?

Oh, now that is a royal bi..ch to find. And the wires are nearly too short to use.
There are you tube videos that help and even then you'll hate life.

 

[soulezoo]

Light bar
Ham radio
Air compressor
Gas transfer tank

 

[cntyguy]

1 - Onyx6 lightbar
2 - Morimoto a-pillar lights
3 - BD S2 ditch lights
4 - BD S2 reverse lights
5 - ARB compressor
6 - Air horn

i remember thinking when I first got the truck what in the world will I need six aux switches for? Now I’m wishing I had another six!

 

[Supercup]

1. Baja Design pocket light - squadron Pro - (I have SAE wired to OEM fog light switch)
2. Baja Design back up lights (S-2's flush mounted in rear bumper).
3. Open - may add A-pillar ditch lights on this one
4. Air compressor for air bags
5. Baja Design Onyx 6 Arc 40" dual control - clear half
6. Baja Design Onyx 6 Arc 40" dual control - amber half

 

[Modman]

1 - Aux reverse light
2 - empty
3 - empty
4 - ARB compressor
5 - Dometic fridge
6 - Supplemental horn

 

[Dented]

Empty
Empty
Empty
Back up lights
Empty
Girlfriend Mute

 

[Lunch Box]

Empty
Empty
Empty
Back up lights
Empty
Girlfriend Mute

1. Z- Flash
2. Front/rear bumper side lights & auxiliary
back up lights
3. Fender vent lights
4. Amber fog lamps
5. Front bumper 36 inch light bar
6. Fender ditch lights