🛠️ What did you do to your Tremor today? [2026 edition]

Took my grill off and pulled the driver fender liner to install Putco emblem. Decided the emblem was kind of bland (very rough finish, matte so doesn’t really match the black grill) and the light plug would be a significant challenge from the fender area. I was not going to pull the bumper as per Putco. I could have done the fuse box tap but just wasn’t feeling it. Sent it back to Putco. Might do the factory BAP emblem or maybe a custom painted one. Probably the former.

On the fender liners, I found that the 5.5 mm head bolts can be removed using a 7/32” socket. I only had 5 and 6 mm on the metric side

The Putco factory style wiring harness was really nice.
 
Last edited:
That's your 4WD binding on pavement. I wouldn't do that ;)
or

use slippery but not 4x4

it'll make the throttle less responsive. less prone to break loose on ya, but the binding should go away. then again, traction control should hand it just fine in normal &/or eco mode too.

deep sand & snow will do the opposite. throttle will be way more responsive & lively.

but just as @McE stated, if you're in 4x4 turning is going to cause binding especially if you have the rear locker engaged too. never on pavement except straight.
 
It's raining in El Paso again. For like 10 minutes, but a good down pour. So I switched to Slippery Roads drive mode. Is it a bad sign that when at a very slow speed, it is very twitchy? Kind of lurches and resists moving while turning? It also feels like it is resisting moving at high way speeds.

Given the system allows the owner to user Drive Modes in either 2wd or 4wd, I'd believe you were not in 4wd. Seems the Slippery Mode isn't specifically or intended for use in rain by the manual.

Depending on your vehicle’s options, this
feature adjusts all-wheel drive control to
provide optimum traction for slippery
surfaces.
Use this mode for less than ideal road
conditions such as snow and ice covered
roads or for firm surfaces that are covered
with loose or slippery materials.

:cool: :cool: :coffee: :coffee: 🇺🇲 🇺🇲 🇺🇲 🇺🇲
 
1000014196.webp
1000014206.webp
1000014216.webp

So, the badlands will work with the RC hidden mount. The freespool lever needs chopping (not as much as I did 😬🤣).
So the winch itself needs modification too. I had to take the control box off and move it behind the grill. I took the whole case off of the control box and relocated the remote plug and the wireless switch. I also had to take apart the planetary gear box and remove the extra empty case on that end in order for it to sit inside the winch mount. Took me a couple hours to get the damn thing back together which was infuriating to say the least.
I'll get more pics maybe tomorrow but for now it is installed and only needs to be wired into the battery. I did run it a couple times before I shut the front end up and she seems to work 🤷🤣
1000014229.webp

Here are the extra bits I removed to make it work
 
Last edited:
Well got the BMC fog light kit installed today and the outer ambers on the OEM fogs wired. Still need to wire the Squadrons to the upfitter switch.
IMG_1459.webp
IMG_1454.webp
 
Given the system allows the owner to user Drive Modes in either 2wd or 4wd, I'd believe you were not in 4wd. Seems the Slippery Mode isn't specifically or intended for use in rain by the manual.

Depending on your vehicle’s options, this
feature adjusts all-wheel drive control to
provide optimum traction for slippery
surfaces.
Use this mode for less than ideal road
conditions such as snow and ice covered
roads or for firm surfaces that are covered
with loose or slippery materials.

:cool: :cool: :coffee: :coffee: 🇺🇲 🇺🇲 🇺🇲 🇺🇲
On the 2023+ trucks, it will automatically shift into 4Hi when you select Slippery mode (or Offroad/Deep Snow + Sand etc). Instead of the "4x4 Recommended" splash screen that you could just click "Ok"/ignore on the 2020-2022 trucks.
 
IMG_8388.webp

Scary McOwl sits on my rig these days at home. A very territorial female cardinal keeps attacking her image in the big shiny truck window.

I also set an appointment with Prestige film. I figured 35 all around, 70 on the windshield with a brow and 5 on the sunroof. Consider South Louisiana and Florida summers.
 
Thank you for the advice on the Slippery Roads drive mode. I was concerned that there was a defect. It is good to hear it is just my incompetence, and not mechanical failure.
 
View attachment 255138Installed two unrelated things behind back seat:
  1. ARB compressor
  2. ICOM ham radio

View attachment 255139
View attachment 255140View attachment 255141View attachment 255142View attachment 255148

Air compressor:
  • Protected from elements compared with exterior mounting
  • Large diameter, metal-reinforced air hose essentially acts like a small air reservoir
  • Probably overdid the power wires (4awg through passenger floor grommet)
  • Gets hot, so have to drop seat back for heavy use :(
  • Made a DIY 4-tire inflation with flexzilla hose
  • On upfitter switch 5 to run with battery (although should run truck for any serious use)
Radio:
  • Faceplate looks factory up by the upfitters
  • Radio box hidden away behind back seat
  • Antenna bracket screws in behind reverse light (no holes in truck)
  • Home-ran and isolated the power wires to secondary battery (trying to avoid interference)
  • Speaker is under back seat with holes drilled to let sound through, then covered with standard speaker cover.
  • Radio can do 2m and 70cm, plus marine, GMRS, and MURS (although not legal in these bands)
  • No more sunglasses holder :(
  • Not sure 2-way radio is worth it anymore with cell phone reception getting so much better (radio is for hunting, not SHTF)
Tell me about the radio sunglasses mount and the antenna!
 
Thank you for the advice on the Slippery Roads drive mode. I was concerned that there was a defect. It is good to hear it is just my incompetence, and not mechanical failure.
We’ve all been there at one point or another! Anyone that tells you they’ve never learned anything the hard way is a liar 😂
 
We’ve all been there at one point or another! Anyone that tells you they’ve never learned anything the hard way is a liar 😂
I've never learned anything the hard way but the girls have! 🤪
 
I've never learned anything the hard way but the girls have! 🤪
That sentence went through the phrasing department completely unsupervised 😂

Should…should we be worried? 😜
 
Back
Top Bottom