I believe our man MVI is at factory Tremor Packge height.
I'm jealous of the time it took!
Three days later I'm still installing a set of Full Travel Bags!
(a few hours here, a few hours there. I have other chores sprinkled into my day)
FullTravelBags gives a complete kit - in the case of the Super Duty Tremor, the factory, top overload spring and it's top spacer are permanently removed requiring the removal and replacement of the leaves' center bolt as the factory bolts aren't threaded far enough (their grip length too long).
reassembled leaf pack sans overload spring and new, correct length U-bolts torqued to 140 lb ft. Try that while laying on your side. Fun!
The removable bags' cradles are the genius of FullTravelBags!
Mocked up and to aid upward bias of the top bracket for bottom holes' marking with a 7/16" transfer punch
Drilling two holes per side is required. Bottom holes drilled here are also chamfered, and seen here coated in anti-seize as a knee jerk attempt as a rust inhibitor.
Directions suggest working one side at a time. Here, the driver side of the axle is elevated (for tire removal) and the suspension very slightly compressed. Proper distance for cradle block insertion will be restored when tire fitted with the truck's corner weight on the ground.
Upper 5/8" bolts are torqued to 120 ft/lbs as they use the factory fifth wheel frame prep, the lowers (since no crush sleeves between the walls of the frame, there) are torqued to 20 ft/lbs. Premium quality hardware supplied. Washers, too. Carroll Smith would be happy!
Today I head outside to start the passenger side. I plan to leave Monday or Tuesday morning for points north! then two days after that travel from there to Moab (five hours' drive) for a noon arrival to a Tremor gathering. I'm excited!
