🛠️ What did you do to your Tremor today? [2026 edition]

Installed Open Trail Creations 8-wire Upfitter solution and the Grounding solution. Most likely grounding lights that are close to the front there. Easy install and when I had a dumb question, @trmrzla was quick to help!


I am getting @OmahaBravo to sell me some BD Squad 2 Pros as a-pillar lights and will see if I feel like I need more forward. Mostly want the ditch zone lit up for deer here. And plan on getting 45deg rear bumper pocket lights for lighting the sides of the trailer…..
 
Installed Open Trail Creations 8-wire Upfitter solution and the Grounding solution. Most likely grounding lights that are close to the front there. Easy install and when I had a dumb question, @trmrzla was quick to help!


I am getting @OmahaBravo to sell me some BD Squad 2 Pros as a-pillar lights and will see if I feel like I need more forward. Mostly want the ditch zone lit up for deer here. And plan on getting 45deg rear bumper pocket lights for lighting the sides of the trailer…..
Thanks again!
 
First tow with the Timbrens yesterday and the truck felt much more in control than before and no more sagging rear end. First picture was from last year and an empty bed and the second with the cap has a couple of hundred extra pounds with the cap and tools in the truck. I'm pretty impressed with these.


IMG_3873.webp


IMG_8447.webp
 
First tow with the Timbrens yesterday and the truck felt much more in control than before and no more sagging rear end. First picture was from last year and an empty bed and the second with the cap has a couple of hundred extra pounds with the cap and tools in the truck. I'm pretty impressed with these.


View attachment 270887

View attachment 270888
Do have pictures of just the truck overload spring while not hooked up?
I am about 1-1.5 inches away from contact with my truck as it normally sits with all of my stuff in it.
 
First tow with the Timbrens yesterday and the truck felt much more in control than before and no more sagging rear end. First picture was from last year and an empty bed and the second with the cap has a couple of hundred extra pounds with the cap and tools in the truck. I'm pretty impressed with these.


View attachment 270887

View attachment 270888
That was my first impression as well... A few years later still have nothing negative to say.
 
How much daily weight are you carrying?
Usually not much on a daily basis in the bed or on the hitch. Mainly the fuel tank and whatever is in there - probably a few hundred pounds. Lately I've been using the 20' enclosed trailer a lot since we are in the process of moving. That's usually ~500lbs tongue. Haven't had any time for RV trips this year but that is ~1200lbs tongue.
 
Do have pictures of just the truck overload spring while not hooked up?
I am about 1-1.5 inches away from contact with my truck as it normally sits with all of my stuff in it.
Same - about that distance away with no hitch load.
 
Usually not much on a daily basis in the bed or on the hitch. Mainly the fuel tank and whatever is in there - probably a few hundred pounds. Lately I've been using the 20' enclosed trailer a lot since we are in the process of moving. That's usually ~500lbs tongue. Haven't had any time for RV trips this year but that is ~1200lbs tongue.
Also, this guy is the reason I bought them so may be responsible for the placebo, if that’s the case. I haven’t had a chance to snap photos but my perception is a noticeable improvement in porpoise related motions.
 
Same here, the Fox HTOs feel much better than the original stock shocks. My stock shocks were still somewhat OK but I finally replaced them and FINALLY found a secret low speed rattle that has plagued me since I bout the truck. The rear shocks were causing the rattle.

Did a small trail yesterday, new shocks feel planted on the road and handle the dips and bumps OK. I chose to put boots on the rears to keep rocks from possibly damaging them. I do a lot of rocky road excursions around here. I did find a couple of dings on the old shock housings.

20260920_122910.webp
20260920_122736.webp
 
Also, this guy is the reason I bought them so may be responsible for the placebo, if that’s the case. I haven’t had a chance to snap photos but my perception is a noticeable improvement in porpoise related motions.
Are you running the regular timbren or the spacer one "for lifted trucks"
 
Are you running the regular timbren or the spacer one "for lifted trucks"
These.

 
These.

Gotcha, that's the one for "regular trucks". Says tremors need the one with the spacer.
 
Gotcha, that's the one for "regular trucks". Says tremors need the one with the spacer.
Right. I don’t need them every day engaged. So there is an inch or so of space when the bed is empty except for the toolbox.
 
Right. I don’t need them every day engaged. So there is an inch or so of space when the bed is empty except for the toolbox.
That's the one I need then. I just wanted to make sure that it wouldn't be in contact 24/7. Just when I am pulling one of the heavier trailers. 😎
 
I did that on my Power Wagon, didn’t put the 1” spacer on my airbags since I had Daystars. Helped for normal driving but jumps could still be harsh. The Timbrens on my Chevy 2500 were borderline scary in high speed whoops as the rear would bounce right off the ground. I just had 5100s so probably not enough rebound.
 
Same here, the Fox HTOs feel much better than the original stock shocks. My stock shocks were still somewhat OK but I finally replaced them and FINALLY found a secret low speed rattle that has plagued me since I bout the truck. The rear shocks were causing the rattle.

Did a small trail yesterday, new shocks feel planted on the road and handle the dips and bumps OK. I chose to put boots on the rears to keep rocks from possibly damaging them. I do a lot of rocky road excursions around here. I did find a couple of dings on the old shock housings.

View attachment 270925View attachment 270926
Is the picture or do you only have 2” of uptravel on the front shocks?
 
Is the picture or do you only have 2” of uptravel on the front shocks?
Closer to 2.5 inches. They look short but the compressed size is about the same as the stock ones. (I had to look at this many times and rechecked the part numbers, they all say it is the correct ones.) Would be nice if I could have someone else verify this as well. The vendors are all over the place on the correct info, seems no one has a good answer. Same with the rear shocks.

Check this out for comparisons:

REAR Fox 2.5 HTO Series SHOCKS

Specifications of the 987-24-003: (Rear Lift 2-3.5)
Body Diameter (in): 2.5
Body Material: Aluminum
Bottom Mount: Eyelet
Compressed Length (in): 19.39
Extended Length (in): 30.58
Reservoir Type: Internal Floating Piston
Series: Performance
Top Mount: Eyelet
Travel (in): 11.19
Type: Smooth Body

Specifications of the 987-24-001: (Rear Lift 0-1.5) (Recommended for Tremor)
Body Diameter (in): 2.5
Body Material: Aluminum
Bottom Mount: Eyelet
Compressed Length (in): 18.79
Extended Length (in): 29.58
Reservoir Type: Internal Floating Piston
Series: Performance
Top Mount: Eyelet
Travel (in): 10.79
Type: Smooth Body

Specifications of the Stock Tremor as Measured: Rear (22YM)
Body Diameter (in): 2.5
Body Material: Steel
Bottom Mount: Eyelet
Compressed Length (in): ~19.00
Extended Length (in): 30.58
Reservoir Type: ***
Series: Ford Spec
Top Mount: Eyelet
Travel (in): 11.58
Type: Ford Spec


FRONT Fox HTO Series SHOCKS

Specifications of the 987-24-002: (Front Lift 2-3.5)
Body Diameter (in): 2.5
Body Material: Aluminum
Bottom Mount: Eyelet
Compressed Length (in): 15.80
Extended Length (in): 23.99
Reservoir Type: Internal Floating Piston
Series: Performance
Top Mount: Stem
Travel (in): 8.19
Type: Smooth Body

Specifications of the 987-24-000: (Front Lift 0-1.5) (Recommended for Tremor)
Body Diameter (in): 2.5
Body Material: Aluminum
Bottom Mount: Eyelet
Compressed Length (in): 14.80
Extended Length (in): 22.19
Reservoir Type: Internal Floating Piston
Series: Performance
Top Mount: Stem
Travel (in): 7.39
Type: Smooth Body

Specifications of the Stock Tremor as Measured: Front (22YM)
Body Diameter (in): 2.5
Body Material: Steel
Bottom Mount: Eyelet
Compressed Length (in): ~14.20
Extended Length (in): 21.50
Reservoir Type: ***
Series: Ford Spec
Top Mount: Stem
Travel (in): 7.50
Type: Smooth Body
 
Back
Top Bottom