Banks iDash installed, linked to Pedal Monster, First step disconnect both batteries' negative terminals, safety step as the there is an airbag in the A Pillar.
Prep Work:
Not being able to stand the black dash pod used ColorBond Ford Light Graphite and Adhesive Promoter color matching as best possible the gray interior
- Used magnetic helping hands to set up pod, in my "paint booth.
- Rough up the pod with 600grit, wipe down with alcohol removing and sanding dust and grease spray Adhesive Promoter, let dry then light coats of color
- The color is not a 100% match, it was a close as I could get.
My professional paint booth with pod ready for paint
Painted pod mocked up on A Pillar and A Pillar trim piece
A Pillar trim pad will need to be cut in order to have pod fit as flush as possible, used blue tape to protect working surface. Using an X-Acto razor saw makes a very clean cut, finish work done using a Dremel tool sanding drum curves the cut to match the pod's for clean flush fit.
Used provided bit by Banks to drill 16mm hole in A Pillar, single pod mount, 18mm hole for dual pod mount. Used blue tape @16mm on bit, setting correct depth
Reassembly:
- Test fit the A Pillar and pod insuring there is at least 1.5 inches of wiring, 4 pin and 6 pin connectors, past the edge of the pod. This is necessary to have enough slack to connect the iDash.
Note, lesson learned once A Pillar is fully seated it's a tight fit, and you won't be able to pull on the wires to get more slack. Learned this the hard way not having enough slack to connectors, had to unbolt A Pillar adjust the wires then reinstall A Pillar
- Seat the A Pillar and install the top bolt.
- Using the provided Allen head screw and Allen wrench - install the pod on the A Pillar.
- After trial and error and exercise of my 4 letter vocabulary
, discovered the best method due to the angle of the Allen head to the A Pillar was to seat the allen head on the Allen wrench's ball end. Thread the wires thru the pod, then fully seat the pod on the A Pillar, in its final location, which seems to line up the Allen head correctly, then tighten with the wrench.
- Reconnected batteries, engine running tested iDash and Pedal Monster downloading any firmware updates before buttoning up trim panel and weather stripping
Tie wrap wires as necessary - reinstall trim panel and weather stripping
Finished,
FWIW, had to look this up, the normal iDash shut down is 30 seconds after the engine is shut down.