Nice! What’s the torque specs during installReplaced the garbage plastic BoxLinks with Machined Aluminum Billet. (Full disclosure, I make these and put them on my FIL's truck)
View attachment 243222
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Nice! What’s the torque specs during installReplaced the garbage plastic BoxLinks with Machined Aluminum Billet. (Full disclosure, I make these and put them on my FIL's truck)
View attachment 243222
Now that is sexy.View attachment 243328installed the new DTE module which was very easy.
Kinda looks like your catalytic convertor went supernova.
This is good to hear; was hoping people would report back that the install isn’t nearly as bad as the instructions make it look.View attachment 243328installed the new DTE module which was very easy.
That looks good! and your off the ground now
The BoxLink ones you make come with the replacement plate, correct? These look like they'd be compatible with the BuiltRight molle panels, correct?
The BoxLink ones you make come with the replacement plate, correct? These look like they'd be compatible with the BuiltRight molle panels, correct?
(Just want to make sure because I also see you make the version to replace the factory D-rings too, but you have a listing for a separate plate for those.)
More stuff to add to the favourites list...
Beauty, I'm pretty sure I read that, but not sure how I missed the mounting plates in there. I reed gud.
Where are you mounting these? Bumper bracket or ??Next lighting mod, just need the storm to pass and temps to warm up so that i can work on it outside.
View attachment 243560
Where are you mounting these? Bumper bracket or ??
On the axleIf i asked folks to take a guess i bet no one would even think of the location i came up with for them on the rear of the truck![]()
Ok... Across the DB cover. (First guess)If i asked folks to take a guess i bet no one would even think of the location i came up with for them on the rear of the truck![]()
Rear bumper steps perhaps??If i asked folks to take a guess i bet no one would even think of the location i came up with for them on the rear of the truck![]()
If i asked folks to take a guess i bet no one would even think of the location i came up with for them on the rear of the truck![]()
That was my first choice. The problem was tilt on the DB edges. These pods have 20 degrees of tilt each way and DB edge angle is 45 degrees, so at best i would have these pods pointed upward at 20 degrees. Not ideal. On the plastic, i can have them pointed straight at zero degrees, acceptable.Ok... Across the DB cover. (First guess)