- May 31, 2020
- South Carolina
- Retired Army
- Current Ride
- 2020 F-250 Platinum Tremor
The parts guys (2 diffevent dealerships) have said I need to run it through Service to use the points. I’m not that worried about it, I’m sure they can figure it out since they are the “largest Ford volume dealer in the world”.All you do is tell the parts guy you want to use your points and they will look up your vin.
My quick lube guys had no problem using the email on my ford pass account and charge an oil chg using 15000 of my 75k points on thier POS system.The parts guys (2 diffevent dealerships) have said I need to run it through Service to use the points. I’m not that worried about it, I’m sure they can figure it out since they are the “largest Ford volume dealer in the world”.
Picked up the OEM mud flaps today, and had them order me the sun shade, and the dealer had no problem with the FordPass points.
But when I got home and checked the kit out I saw that they were sent the incorrect rear set (got the ones for no fender trim). So they are ordering the right ones and I’ll pick them up on Saturday and try this again.
Correct part numbers for those interested:
HC3Z 16A550 CA - Fronts
HC3Z 16A550 DA - Rears
I picked up the sun shade last week. Very well built. I was expecting a flimsy ordinary one.
I bought one for my 2015 that I’ve been using in the Tremor. It’s close, but not really big enough and wants to fall down. So I was going to be buying a new one, but figured I could use my FordPass points and save a. Few bucks.I picked up the sun shade last week. Very well built. I was expecting a flimsy ordinary one.
Installation uses body clips and screws into all existing holes with no modifications to the truck, so you should be able to remove them just fine.Can the OEMs be removed without leaving any permanent modifications / holes behind? Not sure I'm a fan of them and the truck I just located has them on already.
Wouldn’t happen to have those instructions handy would you? Picked up the correct rear set today and checked to make sure all the hardware was there, but no instructions.ok ok... sorry for all the posts but the reason i wasnt able to do the rear flaps is i was missing pages 5,6 of the manual and hadnt noticed . Called OEMselect and I got the manual and put the flaps in in a matter of minutes. The ford oem wheel wells i put in the rear kinda got in the way a bit but was able to push my way around em.
View attachment 2552View attachment 2553 View attachment 2551