πŸ“ Meet-Up Meetup and Trail Run - Arizona - Saturday, November 14th - Post #1 Updated With All Information

Added to Calendar: 11-14-26

Meet-UpπŸ“
What's next? 😁
lights?!?!

1795232530335.webp
 
I too finally had a chance to wash off some of the mud and fully inspect my truck. I am very glad that I had skid plates on everything, they definitely did their job, and all of them held up to the punishment with flying colors. The only β€œdamage” I suffered is a twisted shock mount. I have a plan to fix it with the help of two additional trucks as anchor points, some snatch blocks, my winch and a giant ass wrench I have that will fit over the entire mount.

I’ll try and film the operation when I get a chance to attempt it, good or bad, it will be entertaining!

IMG_1461.webp
 
Last edited:
I too finally had a chance to wash off some of the mud and fully inspect my truck. I am very glad that I had skid plates on everything, they definitely did their job, and all of them held up to the punishment with flying colors. The only β€œdamage” I suffered is a twisted shock mount. I have a plan to fix it with the help of two additional trucks as anchor points, some snatch blocks, my winch and a giant ass wrench I have that will fit over the entire mount.

I’ll try and film the operation when I get a chance to attempt it, good or bad, it will be entertaining!

View attachment 280183
I wonder if you could just bang it back into its original position?

I don’t see how using a winch would straighten it, to be quite honest. The short base doesn’t provide enough leverage to bring it back; if it were longer, a winch pull might work, but in this case, it won’t generate sufficient force in my honest opinion. You're just going drag your truck along with any others used as anchors, and the awkward angle from the front winch makes it even less effective even with reoutes along the way. It’s just not ideal.

You could try welding something to it and pulling it from that but then that just gets messy.

I would heat it up with a torch, take a good wack on it with a nice 10lb sledge and I bet that puppy starts to bend back.
 
I will film it, then it will make sense. Too hard to explain clearly in writing.
 
Interesting when I imported the route shared by @Toxophilite into Tread 2 - found that while OnX Offroad was dependent upon WiFi and celluar - not having Starlink-and on the trail OnX Offroad wasn't available.

The Garmin Tread 2 always had sat reception and mirrored the trail we ran, from the shared route @Toxophilite created.

Just another means to naviagate just incase 😁
 
Interesting when I imported the route shared by @Toxophilite into Tread 2 - found that while OnX Offroad was dependent upon WiFi and celluar - not having Starlink-and on the trail OnX Offroad wasn't available.

The Garmin Tread 2 always had sat reception and mirrored the trail we ran, from the shared route @Toxophilite created.

Just another means to naviagate just incase 😁
Very interesting to know, indeed for future runs.

I had my starlink up - I could have shared my connection with you guys.

It has enough range to support the small group we had on this trail.
 
Back
Top Bottom