Adaptive Cruise Control relocation

[Wirelessguy]

See my posts above, just get it precisely perpendicular to the front of the truck, that’s where it is set from factory.

Unlike others who ran re-calibration and still experience issues, i measured mine while relocating acc; i haven't had a single error message, haven’t had a single problem in the 6000 miles half of it driving to florida and back mostly in ACC mode. It continued to work exactly the same as it did before relocation.

I thought that perpendicular is the first spot I started with, now I have the grill on so I’m using a socket and level to adjust the sensor.

Maybe I installed the bracket itself a little crooked.

I also extended the connector myself but I doubt that’s the issue, each wire was individually soldered and covered with heat shrink.

I’m headed to a UTV event in Green River Utah this weekend so I’ll dig in once we get settled.

I installed the controller box just to the right of the sensor and the power wires across the bottom of the bracket, maybe that’s an issue.

 

[Momma’s Trim!]

Will this work on a Platinum Grill 2022?

 

[Wirelessguy]

Will this work on a Platinum Grill 2022?

Here is the link to the fitment, the one I used starts at model year 2023. ACC bracket

 

[512Tremor]

Has anyone had any problems doing this in the platinum grill? I think I’m about to try this so I can make room for a winch.

 

[512Tremor]

Had anyone installed the ADD relocation bracket on a Truck with the platinum grill? It says it won’t work with it because of the reflective grill.

 

[AZsurveyor]

Had anyone installed the ADD relocation bracket on a Truck with the platinum grill? It says it won’t work with it because of the reflective grill.

I never have but it is true, they will not work unless your grill is black.