Probably, however 460 bucks to lower steps….might have to wait on this for a bit,
Lowered Factory Steps
- OP 🔹 Jeepdude665
- Start date
I just did the bracket switch on my Tremor from the high board setup that came with the truck to the lower SD brackets. I can confirm that the part number is HC3Z16A506AB. I ordered four of them from a local dealer. They were not cheap, $500+ for all four of them. Money well spent as the boss can now easily get in the truck. Total time for swap out was roughly 30 minutes. You will need a 10mm wrench/socket for the four bolts in the boards and a 13mm wrench/socket for the three nuts on the cab.
I plan to try and sell the tremor brackets once I get my 5 posts completed.
I plan to try and sell the tremor brackets once I get my 5 posts completed.
