-
Featured
- #1
So after trial and error of other products I've finally made a solution and I feel it works well.
Purchased Camera relocation bracket from @OffroadAlliance - They were an awesome help and had it in stock ready to ship, don't hesitate to buy from them!
offroadalliance.com
ended up purchasing a right angle extension on amazon, since the straight one I had put pressure on the connector hitting the LP9 - First pic is with the straight connector.
I had to get the Dremel tool out to modify to fit between the LP9's, if you're using LP6's you may not need to modify, can't attest to spacing when using the Factory Aftermarket bar vs the intended ADD bumper use. I also had to drill a small hole in the side to use the original factory camera. I was over trying and returning multiple camera options. If I can confirm a different camera that works that has a rear connector I will swap it out later for a cleaner look.
Here's some installation pictures:
Old Picture, with Straight Extension Harness
After with right angle extension harness - Before I added head shrink to protect and cover blue connector. Wire is managed now too. (I'm going to Cleanup the cut marks this weekend and paint black)
Here's a shot of the 360 before I adjusted the angle, I got it a lot closer after adjustment - not 100% exact to stock stitching, but very close and useable.
Purchased Camera relocation bracket from @OffroadAlliance - They were an awesome help and had it in stock ready to ship, don't hesitate to buy from them!
SwarfWorks 360 Camera Relocation Kit for ADD Pro Bumper w/ Light Hoop - SW-CRLA-A01
SwarfWorks 360 Camera Relocation Kit for ADD Pro Bumper w/ Light Hoop - SW-CRLA-A01 360 Camera Relocation Kit for ADD Pro Bumper w/ Light Hoop<br/>This bracket and housing will relocate your factory 360 camera on the 802a Raptors. This mounts to the side brackets on the LP6's. This ONLY works...
offroadalliance.com
ended up purchasing a right angle extension on amazon, since the straight one I had put pressure on the connector hitting the LP9 - First pic is with the straight connector.
I had to get the Dremel tool out to modify to fit between the LP9's, if you're using LP6's you may not need to modify, can't attest to spacing when using the Factory Aftermarket bar vs the intended ADD bumper use. I also had to drill a small hole in the side to use the original factory camera. I was over trying and returning multiple camera options. If I can confirm a different camera that works that has a rear connector I will swap it out later for a cleaner look.
Here's some installation pictures:
Old Picture, with Straight Extension Harness
After with right angle extension harness - Before I added head shrink to protect and cover blue connector. Wire is managed now too. (I'm going to Cleanup the cut marks this weekend and paint black)
Here's a shot of the 360 before I adjusted the angle, I got it a lot closer after adjustment - not 100% exact to stock stitching, but very close and useable.
