OpDawg
Tremor Buff
- Joined
- Nov 19, 2020
- Messages
- 63
- Reaction Points
- 119
- Location
- Maine
- Current Ride
- 2021 Ford F-350 Tremor (Antimatter Blue)
It’s still been doing it a couple miles down the highway. But yesterday it went back to full time “pre-collision assist unavailable” mode, which doesn’t allow me to disable it and bypass to normal cruise...
I checked out the module in the front, pulling the trim plastic off and wiggled the module; it did feel loose (which can be the issue). I pulled slightly, popped it out and disconnected/reconnected the wires, tried to put it back in and now the connector doesn’t even begin to look like it fits all the way back (where it’s supposed to go) because the winch mount is in the way?!! Appears the module was just barely placed back on the attachment posts.
Anyone else with a winch & collision assist confirm this mount is installed wrong/right?
I checked out the module in the front, pulling the trim plastic off and wiggled the module; it did feel loose (which can be the issue). I pulled slightly, popped it out and disconnected/reconnected the wires, tried to put it back in and now the connector doesn’t even begin to look like it fits all the way back (where it’s supposed to go) because the winch mount is in the way?!! Appears the module was just barely placed back on the attachment posts.
Anyone else with a winch & collision assist confirm this mount is installed wrong/right?