Mystery wires

tremur

Tremor Fan
Joined
Jul 1, 2021
Messages
31
Reaction Points
83
Location
nj
Current Rides #1
22 Gray F350 Lariat Tremor 7.3L BlackedOut
I'm under my new '22 installing the trailer camera package and found these connectors on the hitch receiver. Anyone have any idea what there for?

16325060595066262113575183214506.webp
 
Gotta check my window sticker but I think I got a feeebie
I believe what ccw is trying to tell you is that those are the wires that would plug into the back of the in-box connector that comes with the 5-wheel prep package. The wires are run standard, but the plug adapter is not installed without the prep package.
 
I believe what ccw is trying to tell you is that those are the wires that would plug into the back of the in-box connector that comes with the 5-wheel prep package. The wires are run standard, but the plug adapter is not installed without the prep package.
Ah yes, that's exactly correct. Sorry if I was confusing. :)

You will have plugs in the bed of the truck, where you would connect your gooseneck/fifth wheel trailer, with the fifth wheel prep package. The stubs underneath the bed are there with all trucks.
 
Would you mind sharing the specs on your trailer camera package?
Yes, interested as well. I bought the TPMS/camera package with my truck even though I won't have the RV until next spring.
 
Sure, Happy to share. I bought the trailer Camera/TPMS for the Ultimate Pro Trailer. I love the 360 cameras with a truck this big, I needed them. On my last truck I bought an aftermarket stereo that had multiple inputs I used to add a backup camera and a wireless trailer camera, worked great, but the wireless signal would drop out on the highway. Hardwired is the way to go.

To install it I removed the Furrion camera from the back, drilled a hole from the bottom of the trailer and used an electrical snake to pull the camera wire. I had to the end of the wire off thought to get it to fit through the small hole. I'll have to solder the connector back on.

On the truck all I had to do is pinch the metal clips holding the trailer connector to the bumper then remove it. Remove the connector and reinstall. The 12 pin camera/TPMS sensor connector was hanging right next to the 7pin harness. Just remove the dummy connector and install into the back of the new trailer connector.

Did this give you the info you were looking for?

-Ken
 
Back
Top Bottom