Light Bar - Factory grill or Bumper

[jrdn003]

Anyone have installed a light bar in their grill or bumper.
i would like some ideas for my tremor

thanks

 

[Yukon Bush Tremor]

There is another thread already started. A few guys have and they look good!!

I was looking at one of the roof mount 54" curved but im on the fence if I wanna do it.

Kevin

 

[Whyte Rhyno]

Someone mounted a cured light bar on top of the front bumper using a modified Zroadz mount. I'm trying to find that thread! I'm thinking about a slim line rigid curved light bar in the same location

 

[Worley]

Someone mounted a cured light bar on top of the front bumper using a modified Zroadz mount. I'm trying to find that thread! I'm thinking about a slim line rigid curved light bar in the same location

 

[StoneGreyTremor]

I know rough country makes one I’m looking at for the 2019 model, not sure if it’ll fit a 2020

 

[Whyte Rhyno]

View attachment 2517View attachment 2518

Yes! I couldn’t remember who it was! Thanks so much.

 

[Worley]

For those that are concerned about drilling a hole in the bumper, a factory replacement bumper cover is only $26. If you decide to remove the light just replace the cover and holes are covered. The mounting bolts that most light bars mount to have changed for the 2020 and the ones that are made for 2020 make the light bar stick out way too far from the grill. It looks bad and affects the front camera view. That’s why I modified the Zroadz brackets to mount as close to the grill as possible.

 

[Dsimons]

 

[driftwoodsvt]

I want a light, but will wait for a bumper so that it looks integrated.

 

[funkin]

Tire Pros did 2x 30” curved rough country with customs mounts and a trimmed grille.

I was thinking of trying to go this route once I get my truck. If there is any interest when I get the mounts cut on my plasma table I could do a run of them. I don’t think the material cost would be too bad.

 

[driftwoodsvt]

^^ That looks decent. I wonder how much % of the light is blocked by the grill.

 

[Whyte Rhyno]

I like the grille integration. I haven't done front lights yet as I'm still waiting for an aesthetic option

 

[Crumbelievable]

Anyone find some brackets for lights? Looking for a lightbar or some pods by the A piller. Can’t find anything produced, looks like only what people can make themselves.

 

[IceSoldier88]

Tire Pros did 2x 30” curved rough country with customs mounts and a trimmed grille.

I was thinking of trying to go this route once I get my truck. If there is any interest when I get the mounts cut on my plasma table I could do a run of them. I don’t think the material cost would be too bad.

That looks great

 

[Bottom Line]

Crumbelievable, check out SDHQ for A-pillar mounts with Baja designs lights.