Diesel Dawg's Antimatter Blue Lariat Build

DieselDawg88

Tremor Fanatic
Joined
Jul 19, 2021
Messages
165
Reaction Points
469
Location
San Diego
Current Ride
2022 F-250
Now that I have received my truck on 10/8/21 the stock FX4 is shown below.
 

Attachments

  • 20211007_151317.jpg
    20211007_151317.jpg
    287.7 KB · Views: 525
  • 20211007_151328.jpg
    20211007_151328.jpg
    361.3 KB · Views: 439
  • 20211007_151342.jpg
    20211007_151342.jpg
    182.4 KB · Views: 424
  • 20211007_151356.jpg
    20211007_151356.jpg
    190.7 KB · Views: 433
Did some Forscan mods to start with:
Bambi mode
Double honk w/o key fob disabled
Triple ding at start disabled
Double ding door ajar disabled
TMPS set to 40 PSI front/rear ( see FordPass screen shot)
Auto Mirror Fold Lincoln mode (note that you need to go to truck settings and enable auto mirror fold. Disabled from factory.)
 

Attachments

  • Screenshot_20211009-225439_FordPass.jpg
    Screenshot_20211009-225439_FordPass.jpg
    145.2 KB · Views: 67
Installed these Husky rear fender well liners. Amazon $75.
About 15 minutes per side. Or 1 beer install. 3 of the 4 predrilled holes work. The bottom back toward the rear of the truck does not line up I guess on a MY22. I just ran a 1/4" drill bit from the back of the factory hole into liner.
 

Attachments

  • 20211010_164702.jpg
    20211010_164702.jpg
    257.9 KB · Views: 88
Got the Baja Design LED fog/Pro's installed today. Takes about 3 hours to install, includes marking existing fog beams on garage door, lunch, several beers, trying to figure out the Aux switch locations first time, etc. I will say BD needs to label the bags better. The 2 Pin splitter was labeled. I laid the lights out on the floor to figure the 8 harness bags out. Vs under the truck looking up. They need to note the drawings for a MY22 there are no torx T25 bolts to remove in step 4.
 

Attachments

  • 20211010_151409.jpg
    20211010_151409.jpg
    260.5 KB · Views: 180
  • 20211010_155556.jpg
    20211010_155556.jpg
    429.3 KB · Views: 189
  • 20211010_155606.jpg
    20211010_155606.jpg
    482.5 KB · Views: 180
  • 16339037558988619877747900237317.jpg
    16339037558988619877747900237317.jpg
    275.8 KB · Views: 185
Took 4WD valance off and put the 2WD version on. It takes about 3.5" out of the height. Removed front license plate as well.
 

Attachments

  • 20211016_094648.jpg
    20211016_094648.jpg
    293.9 KB · Views: 190
  • 20211016_094623.jpg
    20211016_094623.jpg
    260 KB · Views: 189
  • 20211016_094553.jpg
    20211016_094553.jpg
    283.2 KB · Views: 189
Carli 3.5" Backcountry with full Deaver Springs
37x13.5x18 Toyo RT
Method 18x9 +18
Only touches radius arm driver side at full lock as expected
Rare rainy/cloudy day at Ponto Beach, Carlsbad, CA
 

Attachments

  • 20211023_110802.jpg
    20211023_110802.jpg
    219 KB · Views: 453
  • 20211023_110539.jpg
    20211023_110539.jpg
    330.7 KB · Views: 437
  • 20211023_110503.jpg
    20211023_110503.jpg
    328 KB · Views: 397
  • 20211023_110433.jpg
    20211023_110433.jpg
    279.3 KB · Views: 450
Back
Top