Bed bolt size?

[2WheelerFan]

I’m getting ready to install the Ford 5th wheel prep kit and need to remove the bed. I bought a torx plus 24 socket, which the internet said was the right size, but it’s too small. Does anyone know the right size socket I need so I don’t have to buy a whole set of sockets I’ll never use again?

2020 F-250 XLT Tremor

Thanks,

 

[2WheelerFan]

 

[LGTremor]

I went out and measured my bolts and came up with 0.88." Which is pretty close to 7/8" . In Etorx sizes that is a E28. Mind you my bolts are bed lined so YMMV. Your bolts look bare but you have bed liner. How is that?

 

[LGTremor]

Oh wait...do I see a cap there by his left hand? Nevermind then...

 

[LGTremor]

Chart

 

[Colfaxent]

I went out and measured my bolts and came up with 0.88." Which is pretty close to 7/8" . In Etorx sizes that is a E28. Mind you my bolts are bed lined so YMMV. Your bolts look bare but you have bed liner. How is that?

Most installers remove the bed hardware before spraying the box. I know LineX has on 3 of my trucks.

 

[2WheelerFan]

Most installers remove the bed hardware before spraying the box. I know LineX has on 3 of my trucks.

Mine is a factory installed bed liner. I had to cut around the bolts to try the socket I bought, but it’s too small.