Looking to add amber drive LEDs to my 2020 250 Lariat Tremor in the inlets below the factory fog lights. Going to be my first upfitter add on. Any suggestions on light brands and install methods?
Amber Drive Lights
- OP 🔹 LAtremor
- Start date
Baja Designs S2. Look up bbrett, he’s done it already.
www.fordtremor.com
Baja Designs Super Duty Lighting Solutions
Really think this looks good. How much permanent modificaruins (e.g. Drilling and cutting) is necessary? if you don't trim your plastic end caps. then everything is bolt on, no permanent modifications or drilling. If you do trim them, then just buy new ones from the dealership for pretty cheap.
www.fordtremor.com
Here’s the direct link to the post
www.fordtremor.com
Baja Designs Super Duty Lighting Solutions
I just installed my Baja Designs Dual FPK’s today Looks great!! What do you think about fit and finish. Are the mounts flush? I am hoping to have these installed for the life of the truck and wanted to make sure these mounts (not concerned about BD light quality) have the R&D behind it.
www.fordtremor.com
- OP 🔹
- #4
Here’s the direct link to the post
Baja Designs Super Duty Lighting Solutions
I just installed my Baja Designs Dual FPK’s today Looks great!! What do you think about fit and finish. Are the mounts flush? I am hoping to have these installed for the life of the truck and wanted to make sure these mounts (not concerned about BD light quality) have the R&D behind it.
bbrett, Did you add any additional wiring harness, or did you wire direct to the upfitter harness? Just a little pensive about cutting/drilling into my new truck.
Featured Tremor Photos
Featured Tremor Photos
