2023+ Platinum trim P/N

Mister Bevilaqua

Tremor Addict
Founding Member
Joined
Jul 30, 2023
Messages
1,215
Reaction Points
1,768
Location
HTX
Military
ARMY
Current Ride
2023 F250 Lariat Ultimate HO 6.7
I am looking for the part number for the leather trim pieces on the sides of the center console area that runs along each side of the cup holder area. The black leather version specifically for the 2023+ trucks. Thanks for any help.
 
Found this in a Facebook group. The guy dyed the stitching so it blended better. Maybe after this photo? Not sure since it looks light colored still.

1701285633928.png

1701285741412.png
 
I'll look into this, thanks!
 
Yea the plastic trim in the Lariat Ultimate squeaks when touched, it's very annoying and disappointing as a common touch surface in a $95K truck.
 
Would the leather console trim fit a 2022? I like it.
 
I installed the platinum trim pieces yesterday, as noted they solved the squeaking problem i had and look great. I dyed mine as well with the stuff shown, worked great! I also only used like half a capfull of dye if anyone needs a bottle lol.
 
I installed the platinum trim pieces yesterday, as noted they solved the squeaking problem i had and look great. I dyed mine as well with the stuff shown, worked great! I also only used like half a capfull of dye if anyone needs a bottle lol.

Care to post a pic?
 
What was the difficulty level?
2/10. Pop old trim off with flathead and pop the new ones one. It took 10 min total for both sides, including taking the car cover off. Dying the trim maybe took 20 min, i used a q-tip to run along the stitching, leaving it soak for about 5 min-ish per side. Then wiped the excess off with a paper towel.
 
Tan just like the picture up above.

Hmm… I would need the stitching to be white to match my Onyx interior. Would I use dye or something to try and remove the tan color in the stitching… 🤔
 
So which part number is it? Or is it both boxes?
 
Parts ordered, thanks!
 
2/10. Pop old trim off with flathead and pop the new ones one. It took 10 min total for both sides, including taking the car cover off. Dying the trim maybe took 20 min, i used a q-tip to run along the stitching, leaving it soak for about 5 min-ish per side. Then wiped the excess off with a paper towel.

Does the trim pop up or out?
 
Back
Top