I have a free set of viair mounting hardware that I had made for the Viair 385C kit. I recently relocated everything to the bed of the truck and would hate for these to go to waste. If anyone is interested, just pay me for shipping and it is yours. The first one that sends me message gets it...
It doesn’t on the front bar and the rear is very close. If I let cover go all the way back, I just let go and grab it again behind the bars as it’s sliding. It’s by far the best cover I’ve had on any of my trucks.
I finally got around to redoing my Viar compressor setup. There was nothing wrong with the previous setup as it lasted 2 1/2 years underneath the truck just fine. I did have a few air leaks on the extended hoses to the tank, and I had to replace the 80 amp relay one time. I got tired of climbing...
My tank used to be under rear passenger door. Checkout Viar on board air installation topic. My setup is comment #31. I will post my new setup shortly.
https://www.fordtremor.com/threads/viair-on-board-air-intallation.240/page-2#post-5347
There is an Off Road Innovations shop right down the road from my work in Olive Branch, MS. I’ve never used them, but they seem busy all the time.
http://offroadob.com/
For those who installed the dual Viair 485C onboard air systems, you might want to replace the fuse block that came with it. Mine failed and killed both my batteries. It looks like the fuse got hot and melted then caused a bad connection that was arcing out. That fuse should have blown way...
Had a hell of a time catching up with @Sludgemonkey44 in Pennsylvania yesterday. I’ll throw this picture in for the contest. If it wins, it will be for the both of us. You can see the write up about our meet up in link below. What’s better than one Tremor? Three dammit…Cheers fellas!!
Post in...